Re: nokon cables on a calfee
03/28/07 09:20 AM (12.5.186.27)
Edit
Reply
Quote
So to resurrect an old thread here...
I picked up a set of Nokon cables for my Luna and am having a go at installing them myself. I have a few questions for the folks who have installed these:
1. Is there any trick to keeping the metal jacket bits tight and properly positioned on the liner during the installation?
2. I don't understand how one would go about splicing the liner for long runs (like for the rear brake). The rear brake set assumes one has cable stops and gives 2 liners. I picked up an extension kit as well based on some of the feedback here, but I don't see how one would tie multiple liners together. I have found you can buy a 5M run of liner, is this what most use?
I'm halfway considering creating a step-by-step photo how-to of this little project just because I have yet to find a good resource online. The pez article is about the closest thing to good advice I have found.
Previous
Thread Index
Next
Flat
Re: nokon cables on a calfee
Edit
Reply
Quote
